A cold room that is running warm is a stock problem first and an equipment problem second. Protect the stock, then work out what changed.
The checks below are the order we work in, because the cheapest causes are also the most common. None of them require opening the refrigeration circuit.
1. Protect the stock
Move high-value and high-risk product to a working unit if you can, and keep the door closed. Every time someone opens the door to check the temperature, warm humid air goes in and the room loses ground.
2. Look at airflow
The evaporator has to move air across the whole room. If it is blocked, the room will stratify: cold near the unit, warm at the far end, and the thermostat reading whichever pocket it happens to sit in.
- Stock stacked above the evaporator or tight against the fan guard.
- Cartons or pallets blocking the air stream along the ceiling.
- Evaporator fans not turning, or turning slowly.
- A room loaded far beyond what it was designed for.
3. Check for ice
Ice on the evaporator is an insulation layer. It reduces heat transfer, restricts airflow and makes the unit work harder for less result. Heavy ice usually means a defrost fault, a door left open, a failed seal or a drain that is not clearing.
4. Check the door and the envelope
The room is only as good as its envelope. Walk the inside with the door closed and look for the obvious.
- A door that does not sit square, or a seal that has hardened or torn.
- A strip curtain missing where traffic is heavy.
- Damaged panels, gaps at joints, or a broken floor section.
- Warm air entering around a poorly fitted penetration or pipe entry.
5. Then the equipment
If airflow, ice, door and envelope are all sound, the fault is in the refrigeration or control system: low refrigerant charge, a failing compressor, a blocked condenser, a faulty sensor or a control setting that has drifted. That needs proper testing with gauges and a meter.
Tell us what you have already checked, the room temperature, the setpoint and what is stored. It gets us to the right diagnosis faster.
The short version
- Protect the stock before you troubleshoot.
- Blocked airflow and ice build-up cause a large share of warm-room complaints.
- If airflow, ice, door and panels are sound, the fault is in the refrigeration or controls.