Air conditioning faults tend to cluster. Refrigeration faults affect cooling, drainage faults put water where it should not be, airflow faults cause icing and weak performance, and electrical faults show up as tripping, error codes or a unit that will not start.
We test the system before quoting a repair, so you know what has actually failed rather than what might have. If a repair is not worth doing, we will say so and explain why.
Common faults we are called for
The list below covers most of what we find on domestic and small commercial systems in this area.
- Weak or no cooling, often a refrigerant leak, a dirty condenser coil or a failing compressor.
- Water dripping from the indoor unit, usually a blocked or badly drained condensate line.
- Ice forming on the indoor coil or the outdoor pipes, from restricted airflow or low refrigerant.
- Error codes and control faults, including PCB, sensor and communication problems.
- Rattling, grinding or squealing fans and bearings.
- A musty smell when the unit starts, from a damp evaporator and dirty filters.
How a repair visit works
We would rather find the cause than replace parts until the symptom stops. A visit follows a fixed order so that nothing obvious is skipped.
- Electrical checks: supply, current draw, capacitors, control board and safeties.
- Refrigeration checks: operating pressures, superheat and subcooling where they apply, and leak detection.
- Airflow checks: filters, evaporator condition, fan performance and duct restrictions.
- Drainage checks: pan, line, trap and fall.
- A plain-language explanation of the fault, a price for the repair, and a re-test under load once it is done.
Repair or replace
Age, refrigerant type and corrosion all affect the decision. A corroded coil that has started leaking is rarely worth repairing, and older refrigerant types can be costly or difficult to source. Where a repair makes sense, we quote it clearly. Where replacement is the better route, we will tell you and explain the reasoning so you can decide.
On this coastline
Salt air changes the failure pattern. In Bantry Bay we regularly find blocked condensate drains from humid air, and corroded fins on outdoor coils that would still be sound on an inland installation. Units mounted where wind drives spray against the coil deteriorate fastest.
When we repair a coastal unit we also look at why it failed. Cleaning a coil that is packed with salt and dust, correcting a drain that has lost its fall, or moving a unit out of direct spray can prevent the same call-out next season.
Questions about ac repairs
Can you repair a unit that was installed by another company?
Yes. Have the make, model and serial number ready if you can find the plate, and tell us the error code if the display shows one. It shortens the diagnostic work.
Is it worth repairing a unit that keeps losing gas?
It depends where the leak is. A leaking flare joint or valve can be repaired properly. A coil that has corroded through usually cannot, and repeated gas top-ups only postpone the decision.
Why does my aircon leak water only on humid days?
Humid coastal air produces more condensate than dry air. When the drain is partly restricted, the extra volume is what finally shows up as a drip. The drain needs clearing and checking for fall, not just mopping up.