We install walk-in cold rooms and freezer rooms, and we repair rooms that have stopped holding temperature. On a new room the design decisions that matter are the ones made before the panels go up: insulation thickness, door position, evaporator placement, drain route and where the condensing unit can reject heat.
On an existing room, the first job is to find out what has changed. A room that used to work and now does not is usually telling you something about airflow, door seals, ice build-up or a refrigeration fault.
New cold room installations
We size the room and the equipment for what you actually store, how often the door opens and what the room has to hold overnight. A room designed for fresh produce behaves differently from one holding frozen stock or a mix of both.
- Panel assembly with insulated floor, walls and ceiling, and a door that seals properly.
- Refrigeration equipment matched to the room volume, product load and required temperature.
- Evaporator position and airflow that avoid warm pockets and short-cycling.
- Drainage that cannot freeze, block or back up into the room.
- Controls, temperature display and alarms, plus commissioning and a handover.
Cold room repairs
Repairs usually fall into one of four groups, and the symptoms often overlap.
- Refrigeration faults: low charge, a failing compressor, a blocked or iced evaporator.
- Airflow faults: stacked stock blocking the evaporator, failed fans, or a room loaded beyond its design.
- Envelope faults: damaged panels, perished door seals, a door that no longer closes square.
- Control faults: faulty sensors, thermostats, defrost timers or alarm settings.
What we need from you
For a repair, tell us the room temperature now, the temperature it should hold, what is stored inside, and whether the unit is running, iced up or tripping. For a new installation, a floor plan, the available plant space and an idea of daily throughput let us quote properly.
On this coastline
In Bantry Bay, cold room equipment often sits in a service yard, on a roof or against an outside wall where salt and wind reach it. Condensers in those positions need cleaning more often, and corroded fan guards, brackets and electrical enclosures should be inspected before they fail.
Humidity matters too. A cold room door opened repeatedly in humid coastal air draws moisture in, which loads the evaporator and speeds up ice build-up. A good door seal, a working defrost cycle and a strip curtain where traffic is heavy make a real difference.
Questions about cold rooms
Can you repair an existing cold room you did not install?
Yes. We inspect the panels, door, drain, evaporator and condensing unit, then quote the repair. If the room was never correctly sized for its current use, we will say so rather than repeatedly patching it.
How often should a cold room be serviced?
It depends on the room, how busy it is and how exposed the outdoor equipment is. Busy commercial kitchens and coastal plant generally need more frequent attention than a lightly used store room.
The cold room is running but not getting cold. What should I do?
Check whether the evaporator is iced over and whether airflow is blocked by stock, then call us. Keep the door closed and move high-value stock if the temperature is climbing.