Commercial refrigeration has to survive heat, humidity, constant door opening and staff who are focused on service rather than equipment. When it fails, the cost is measured in stock, covers and reputation.
We supply, install, repair and maintain the refrigeration that keeps a food business running: display fridges, prep counters, under-bar units, blast chillers, bottle coolers and the cold rooms they sit alongside.
Equipment we work on
From a single under-counter unit to a full kitchen line, the same principles apply: correct capacity, clean airflow and equipment that can be serviced.
- Display and serve-over fridges for delis, bakeries and cafés.
- Prep counters and under-counter units in kitchens and bars.
- Blast chillers and rapid-cool equipment where food safety depends on cooling speed.
- Bottle coolers and back-bar refrigeration.
- Cold rooms and freezer rooms, including the equipment that serves them.
Installation that accounts for the kitchen
A commercial unit that cannot reject heat will not hold temperature. Kitchens are hot, and equipment pushed into a corner with no ventilation will run itself to failure. We plan positions, clearances and drainage before installation, and we check that the electrical supply is suitable.
- Heat rejection and ventilation for condensing units.
- Drainage for defrost water and cleaning.
- Clear service access, so future repairs do not mean dismantling the kitchen.
- Correct electrical supply, isolation and protection.
Maintenance that prevents service-day failures
Most commercial refrigeration failures we are called to were developing for weeks: a condenser matted with grease and dust, a door seal going hard, a drain starting to block. A planned visit finds those before a Friday night service does.
On this coastline
Salt air and kitchen grease are a difficult combination for a condenser coil. Grease captures dust and salt, the coil blocks, and the unit runs hotter and longer until it fails. Coastal commercial kitchens need coil cleaning on a schedule, not when performance drops.
We also look at where equipment sits. Units in open service yards or against sea-facing walls collect spray, and their casings, brackets and fan motors corrode first. Replacing a fan motor or bracket early is far cheaper than replacing a compressor later.
Questions about commercial refrigeration
Do you supply equipment as well as repair it?
Yes. Tell us what the unit has to do, the space available and the temperatures you need, and we will quote suitable equipment with installation included.
Can you attend a breakdown during service?
Call or WhatsApp with the details and what stock is at risk. We will tell you honestly what we can do and when, and prioritise refrigeration failures that threaten stock.