Coastal maintenance

Salt air and your air conditioner: what corrosion looks like and how to slow it

Why outdoor units in Bantry Bay corrode faster than inland equipment, which parts go first, and the checks that actually delay it.

Bantry Bay sits between the mountain and the Atlantic, and the wind that makes the view so good carries salt with it. That salt settles on every exposed metal surface, including the outdoor unit of your air conditioner or heat pump.

Salt on its own is not the problem. Salt plus moisture is. Together they form a film on the coil and casing that holds damp against the metal, and once corrosion starts it does not stop on its own.

Which parts fail first

The aluminium fins on the condenser coil are the most vulnerable part of any outdoor unit. They are thin by design, because they have to transfer heat, and they corrode quickly once salt sits on them.

  • Condenser coil fins, which corrode and eventually leak refrigerant.
  • Fan blades and fan motors, where salt and dust collect and seize bearings.
  • Mounting brackets and fasteners, which rust through and can leave a unit unsupported.
  • Electrical enclosures and terminal connections, where damp causes resistance and failure.
  • Casing panels and painted surfaces, where chips become rust patches.

What you can see without opening anything

A visual check every few months tells you a lot. With the unit switched off at the isolator, look at the coil through the grille, and at the casing, brackets and fan.

  • White or grey powder on the coil fins, which is aluminium corrosion.
  • Rust streaks on the casing, bracket or the wall below the unit.
  • A mat of dust, fluff and salt on the coil face that does not blow off.
  • Blades that feel stiff, or a fan that rocks when you touch it gently.
  • Water pooling or staining around the base of the unit.

What slows it down

You cannot remove salt from the air in Bantry Bay, but you can stop it sitting on your equipment for months at a time.

  • Rinse the coil with clean water from the inside out, with the power off, then let it dry. Do not use a high-pressure spray close to the fins.
  • Have the coil cleaned properly as part of a service, along with the drain pan and line.
  • Ask for corrosion-treated coils when replacing equipment in an exposed position.
  • Keep the unit out of direct wind-driven spray where the installation allows it, without blocking airflow.
  • Treat small rust spots on brackets and casings early, and replace fasteners that are already wasted.

When corrosion means replacement

Surface corrosion on a casing or bracket is cosmetic and fixable. Corrosion that has eaten through the coil is not. Once a coil leaks, repeated gas top-ups only postpone the decision, and the leak will keep returning.

If the outdoor coil is failing on a unit that is otherwise sound, the honest question is whether a coil repair is sensible against replacement. We will give you both numbers and the reasoning, and you decide.

The short version

  • Salt plus moisture is what drives corrosion, so cleaning and drying matter more than any single product.
  • Coil fins, fan motors, brackets and electrical connections are the parts that fail first.
  • In exposed Bantry Bay positions, cleaning intervals should follow the condition of the unit, not a generic annual schedule.

Bantry Bay · Cape Town

Want this looked at properly?

Send us the equipment details and what you are seeing. We will tell you what the next step is.