A heat pump does not create heat, it moves it. That is why it can heat water using a fraction of the energy an element needs, and also why its performance depends so heavily on the air it is given to work with.
On the Atlantic Seaboard the air is often cold, damp and salty. Each of those has a specific effect.
Why sizing matters more than the label
A heat pump's rated capacity is measured under standard test conditions. Real installations have colder incoming water in winter, colder air, and a household that all showers within the same hour.
An undersized unit will run continuously and still run out of hot water on a cold morning. An oversized unit heats quickly but cycles more, which is harder on the compressor. The right size depends on how many people use hot water, the cylinder volume, and how quickly the cylinder has to recover.
Defrost cycles explained
In cold, humid air, frost forms on the outdoor coil. The heat pump detects this and switches briefly into reverse to melt it, which is normal. What is not normal is a unit that spends long periods in defrost, ices heavily, or takes a long time to recover afterwards.
- Frequent, long defrost cycles can point to a sensor or control fault.
- Poor airflow around the unit makes frosting worse.
- A unit in a damp, shaded, wind-driven corner will frost more than one with good airflow.
- Reduced hot water recovery after a cold spell is worth investigating rather than accepting.
Salt exposure
The outdoor coil is aluminium, and it runs all year. In a coastal position, salt film on the coil holds moisture, accelerates corrosion and reduces heat transfer. A corroded coil has to work harder for the same output, so efficiency drops before the unit actually fails.
Position the unit away from direct wind-driven spray where possible, keep the coil clean, and have the casing, brackets and electrical enclosure checked at each service.
What to check when hot water runs short
Before assuming the heat pump has failed, rule out the simple causes.
- Has the cylinder temperature setpoint been changed?
- Is the cylinder large enough for the household, or has occupancy increased?
- Is there a leaking tap or a burst pipe wasting hot water?
- Is the unit showing an error code, or in defrost when you check?
- Is the outdoor unit clear of obstructions and dirt?
The short version
- Heat pump performance depends on air temperature, humidity and how the unit is positioned.
- Frosting is normal; long or repeated defrost cycles are not.
- Coastal salt reduces efficiency long before a heat pump stops working, so coil cleaning matters.